Birmingham Roof Pros provides professional flat & low-slope roofing in Birmingham, AL for residential and commercial properties across Jefferson County and the Birmingham district. Low slope on a Birmingham house is rarely the main roof. It is the porch, the back addition and the sleeping porch that got enclosed some time after the war. Those planes are where a brick wall and a nearly flat roof meet at ninety degrees.
That junction is the whole job. A low-slope plane running into a two-story masonry wall needs a base flashing turned up the brick at least eight inches above the finished surface. A separate counterflashing is cut into a raked bed joint above it. Where the original builder ran roll roofing up the wall and tarred it, water is already behind the brick.
Crickets on low slope are framed and sheathed, then flashed as part of the membrane, not built out of tapered insulation and hope. Slope decides the material and we measure it rather than guess. Below two in twelve, shingles are outside their listing no matter what anybody tells you, and we will not install them there. Between half an inch and two inches we specify a two-ply SBS-modified bitumen or a single-ply membrane.
Genuinely dead flat gets a tapered insulation package so the water leaves. Ponding is the failure mode nobody prices. A porch roof that holds an inch of standing water for three days after every storm will find the seam eventually. The fix is not more coating. It is a tapered package or a relocated drain. We shoot the plane with a level and mark the low spots on the estimate so the scope matches the problem.
Where a stack passes through a low-slope plane the detail gets harder, not easier. There is no slope to shed water around the brick. The uphill side needs a built cricket even on a small chimney, and the membrane has to be flashed up onto it as a continuous plane. A tar-and-fabric patch around masonry on a flat roof is the single most common thing we tear out.
Old built-up roofs here are often slag-surfaced rather than gravel-surfaced. Slag was the local by-product and it was cheap. Slag is lighter and more angular, it spuds differently, and it changes what a recover weighs. We open a test cut and tell you what is actually up there before quoting a tear-off. Anything at or above two in twelve can take a shingle if it is detailed for low slope, which means a doubled underlayment layer.
Our licensed and insured team brings the right materials and equipment to every job — two-piece counterflashing cut into a raked bed joint, a poured chimney crown with an overhang and a drip kerf, a framed cricket above stacks wider than thirty inches, self-adhered flashing membrane turned up the brick face, sheet-metal thimble covers sealed at abandoned flue openings, corbelled brick stacks standing proud of the ridge — and backs the work with a written workmanship warranty. We serve Birmingham and nearby communities including Hoover, Vestavia Hills, Alabaster, Homewood.
What We Handle
Everything our flat & low-slope roofing in Birmingham covers
One crew, one point of contact, and the full range of flat & low-slope roofing work in Birmingham, AL. If it is on this list we do it in house rather than handing it to a subcontractor:
- flat roof repair birmingham al
- low slope roofing
- porch roof repair jefferson county
- tpo roofing birmingham
- modified bitumen roof alabama
- flat roof replacement birmingham al
- epdm roof repair birmingham
- low slope porch roof
- rolled roofing birmingham
- flat roof chimney flashing
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Birmingham services.
Materials, equipment and how we do flat & low-slope roofing
The difference between flat & low-slope roofing that lasts and flat & low-slope roofing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with two-piece counterflashing cut into a raked bed joint, a poured chimney crown with an overhang and a drip kerf, a framed cricket above stacks wider than thirty inches, self-adhered flashing membrane turned up the brick face, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Birmingham job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in Jefferson County and the Birmingham district means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do flat & low-slope roofing outside Birmingham
Birmingham Roof Pros covers Birmingham and the surrounding communities of Jefferson County and the Birmingham district. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Flat & Low-Slope Roofing in Hoover, AL — Jefferson and Shelby counties, population 92,606
- Flat & Low-Slope Roofing in Vestavia Hills, AL — Jefferson County, population 39,102
- Flat & Low-Slope Roofing in Alabaster, AL — Shelby County, population 33,284
- Flat & Low-Slope Roofing in Homewood, AL — Jefferson County, population 26,414
- Flat & Low-Slope Roofing in Trussville, AL — Jefferson and St. Clair counties, population 26,123
- Flat & Low-Slope Roofing in Bessemer, AL — Jefferson County, population 26,019
Start on the Birmingham Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Birmingham Chooses Birmingham Roof Pros
- ✓We settle the chimney before we price the covering, because on a pre-war Birmingham house that is the item that moves the number
- ✓Every dead flue gets three priced options — rebuild and recrown, cap and keep, or remove below the deck — and we say which we would choose
- ✓Nothing comes down until the fuel question is answered in writing, and a live appliance is re-vented by a licensed mechanical contractor first
- ✓Flashing is two pieces of fabricated metal cut into a raked bed joint, never one piece bedded in sealant
The standards behind flat & low-slope roofing
Quality here is not a matter of opinion — it is written down. The flat & low-slope roofing work we do in Birmingham follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every flat & low-slope roofing project in Birmingham gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free flat & low-slope roofing free estimate in Birmingham, or request a quote and we'll get right back to you.